How To Use Bosch Router Table As A Jointer

Using Router tables as a jointer.

How to use bosch router table as a jointer. Is it possible to use a router table as a jointer. The glue edge is just as good as using a jointer. With the router unplugged use a square and a 12.

Youll have a truer cut when trying to use a router as a jointer with that constant cutting edge. Examine the large hole in the middle of the router table. Straight edges on boards or plywood.

Photo 3 Photo 4. Thank for you idea own dimensions need use buut newererming idea have same i like looking internet lot tool ideas and make some. C-clamp the infeed side of your fence and you are ready to rout.

Hold the router upside down under the table and position it under the insert hole. As with most router table operations there is no need to align the miter track with the fence since it is not used in the jointing operation - the fence guides the stock. The important thing is to make sure that the in-feed and the out-feed side of the fence are parallel and that the out-feedside of the fence is lined up with top dead center of the cut radius of the bit.

And its 2-12-inch dust collection port. Provide easy access to the mains and due power connection and check that the table power switch is operable to be able to activate and turn the tool off when needed. One of the main applications for using the router as a jointer is on very erratic grained woods photo 5 - above.

The Bosch fixed base can be used as a lift in a table. Once I trim the edge I cut a straight edge on the other side using the table saw and then glue up the two pieces. To check if your board is on the right length place it on the infeed table.