How To Solder Thick Wires Together

I plunge the end of the wire into the pool and the insulation burns away in a matter of seconds.

How to solder thick wires together. Apply a drop of solder flux on top of the wire connection. If the wire is stranded twist the strands together with your fingers. Begin by removing the insulation from the ends of both wires you are soldering together.

Preload the Soldering Iron Tip with Solder Wire. For magnet wire I like to set the iron as hot as possible and get a small pool of solder on a chisel tip. Make sure your soldering iron is fully heated and touch the tip to the end of one of the wires.

Lay them together overlapping at the soldered part then blob them together. I then turn down and cool off the iron to do the actual soldering of the now tinned magnet wire. Place tip of soldering iron at the middle of the connection to activate the flux.

Remember to tin the iron before soldering. Heat the end of one wire and coat it with solder. How to Solder Wires to a Tag.

Also do that to the end of the other wire. Flux is a caustic paste fluid or powder that prevents the solder joint from corroding from the heat and allows the solder to flow. The first step in any successful solder joint is to clean the surfaces to be soldered.

Fourth using an iron melt a little solder onto the outside of the terminal sleeve with the. Ad Quality Solder Wire Drawing Machine. Solder the Wire Joint.