How To Make Soldering Iron With Mobile Charger

I just connected the charging leads to a home made hand piece applied it to my brass pieces flipped the switch and applied the solder.

How to make soldering iron with mobile charger. Cut 14 of plastic off of the tip of each wire with the wire stripper so copper wires are exposed. Solder Mount the Regulator. The output power is 30W while TS80 is only 18W.

Before you put solder over the required area heat up the surface to be soldered by touching the tip of the hot iron. Strip the red and black wires. Remove the third wire that is unusable.

Clean the tip of the soldering iron and tin it with solder. Cut the small heat shrink tubing into four equal pieces 1 each. Plug in the soldering iron turn it on and let it warm up for 23 minutes.

Take the 2 solar power panels and cut all four wires to about 1 in length. Put some Flux on the PCB before soldering. Most important thing to be kept in mind when working with soldering iron is not to touch the tip of the iron as it is extremely hot.

The first device used a battery charger that I already had although a new one was about 50. And we made a soldering station where they could build it. The regulator plays an important role in this solar phone charger as it charges the power bank.

Its only 31g in weight and 17cm long. Or why not try to build the mobile phone charger from the video above. TS80P can heat up to 300C in only 8 seconds.