Unable To Tin Soldering Iron Tip

How to Clean Soldering Iron Tip.

Unable to tin soldering iron tip. Keep trying to melt the solder on the paste wet tip as you must tin it before it becomes too hot that it burns out the paste. Steel wool is an abrasive which will damage the tip as will sand paper. The tinning of soldering iron is a simple process.

After a minute or two the iron should be hot enough to steam when touched to the sponge. Melt some good quality of solder wire on the Tip. Plug in the iron and switch it on.

Soak the sponge using the water squeeze it out a little then use it to clean the tip of the soldering iron. Then of course you need to tin the iron again which means adding a fair amount of solder and letting it sit for a few minutes before wiping it clean. A polyurethane foam bar with embedded abrasives which is used to polish the working end of the tip to remove surface oxides.

Your goal is to remove old solder from the tip. Most modern soldering tips are composed of a copper core copper conducts heat excellently encased with nickel-plated iron to repel solder. With the iron tip cold use a polishing bar.

Now as you see ensure to always tin your soldering iron to maintain its good condition. So the immediate solution to this issue is replacing the tip and using a new one and to prevent. The chief reason why the solder is not sticking to iron is the oxidized tip.

It is not as scary or as difficult as you may be thinking. How to Tin or Re-Tin Soldering Iron Tip. The tips are made internally of copper which is great for heat transfer but will be damageddissolved by the tin in the solder.