How To Turn A Hot Glue Gun Into A Soldering Iron

Make sure the glue guns not plugged in if you do this as the mains cable may be wrapped close by the screw bosses.

How to turn a hot glue gun into a soldering iron. Tin the wire by putting the soldering iron to the twisted tip and then touching the wire not the iron. Procure the materials you intend to fuse. This is made for soldering very heavy parts and they can even reach temperatures that are useful for silver soldering using for brass parts and.

Take the X-Acto knife and slice around the edge at the top of the battery. Place your lead component through the hole. Anything higher in wattage and you risk damaging either the component or the board.

Wire optional hot glue gun or soldering iron optional Step 1. Twist the wire round. Two scraps with 5min epoxy left overnight to cure.

Touch the clean tip of your hot soldering iron to both the pad and the tip of the lead you want to solder to the PCB. If its hot enough the solder will quickly flow down the wire. Tried burning with hot iron and a lighter and freezing with a tube filled with whatever comes out of an upside down dustoff can.

Cut Out a Groove. Otherwise prepare them to be heated. You can get most of the glue up this way.

Then the hot air gun is used to bring the component leads up to the solder melting pointThe theory is that this allows much shorter spot heating and less damage to adjacent components. Welcome to the channel Roman Ursu Hack romanursuhack. Irons of the 15W to 30W range are good for most electronicsprinted circuit board work.