How To Solder Wires At Home

If you use flux it must be for electronics any other will ruin the wire in a short time as most are acid.

How to solder wires at home. Doing it correctly will also ensure that you can use your battery when you need to. Making a soldering litz wire is of as following. Hold the two tinned wires on top of each other and touch the soldering iron to both wires.

At some point over the next 2-10 seconds depending on how hot your iron is the wires will be hot enough to melt the solder. If you want to join two wires with solder the first thing you should do is to tin the two wires. Make sure your soldering iron is fully heated and touch the tip to the end of one of the wires.

Remove the soldering iron and allow the soldered connection to cool and harden for a few seconds. A cold solder joint happens when the hot solder hits a cold wire hardening it. 1 clean the wires so they shine 2 twist the wires tightly together and steady the connection with clamps and 3 heat.

This process should melt the solder and coat both wires evenly. Look on the internet how to. Place the tip of the iron on the wire and let it heat for a few seconds.

Too much or too little flux will cause problems with the solder attaching to the parts. Then add some solder until the wire is soaked with solder. If you are soldering wires strip the insulation off the ends of the wires to be soldered together.

Cover the connection with heat shrink. Videos you watch may be added to the TVs watch history. It is as easy as 1-2-3.