How To Solder Two Thick Wires Together

Youll get a straight wire that has a little sideways bump in it so get a larger shrink tube to isolate it youll need two times the diameter of one wire.

How to solder two thick wires together. Un-twist the strands fan out slide the ends strands together overlapping each of the strands so they intermingle roll this area splice in your hands fingers now solder the strands all together on masse. You can also use soldering to fuse two wires together. You should see the solder flow between the strands through the whole bundle.

1 Strip the wires of about 12 in. Place soldering iron under the wire. Heat up the joint and melt the solder with the wire not the soldering iron.

The process of soldering is taking two or more wires and joining them together and then using heat to melt electrical solder connecting those two wires permanently. Strip about 6 mm 14 from the end of the wire. Twist and fold 2.

Touch the tip of the soldering iron to the copper wires. Slide heatshrink glue lined sleeving over the join on the soldered bit only then slide more glue lined heatshrink over the whole of the area an seal the whole lot. Solder is a metal alloy with a low melting temperature point used alongside a soldering iron to permanently join together two metals with a higher melting point.

Place the tip of the iron next to the capacitor and place a bit of solder in between the two. If it is a thick wire you should turn up the heat on your iron if possible to make the wire heat up faster. They should be propped up off the workspace so you can have access to the area under the wires.

There are three common techniques to solder wires together. Apply a drop of solder flux on top of the wire connection. Real tidy with needle nose and only requi.