How To Solder Two Electrical Wires Together

RMA rosin flux is best.

How to solder two electrical wires together. Touch the tip of the soldering iron to the copper wires. The wraps should be adjacent and close to each other. Hold the two tinned wires on top of each other and touch the soldering iron to both wires.

First your wire connection should always be mechanically sound before you solder. For large gauge wires 14awg for an antenna perhaps make a Western Union splice then solder it. Remove the soldering iron and wait a few seconds to let the soldered connection cool and harden.

The best way to splice wires is to wrap them together tightly using multiple twists to ensure maximum contact between the two wire sections. Rather it helps in conducting electricity. Place soldering iron under the wire.

Tin the soldering gun ie melt a little solder on it. There is one way to twist wires together for soldering- a horizontal twist that yields a continues length of wire. Use heat shrink to cover the connection.

Let the solder melt and flow over the wires. So the following technique may be a good technique when soldering ticker wires. There are three main ways to solder wires together.

Screenshot from YouTube video The wires are then twisted together after which they are folded back against the side of one of the pieces of wire as shown below. Do it in such a way that the wraps do not overlay. Be sure to use the correct solder electrical not plumbing and clean the joint with isopropyl alcohol prior to.