How To Solder Car Stereo Wires

You put your heat shrink tubing in the wires and then twist the wires from the new stereo wiring harness to the factory wiring harness.

How to solder car stereo wires. When the wires reach the proper temperature they will begin to drink the solder resulting in a proper connection that will last much longer. Shape the wire ends into a curved hook style. So if you are slopy or a first timer then it may not be for you if you are used to using 44 or something that flows like.

You get the two wires together and then solder them to make a good connection. Solder the power wires to the voltage regulator. Then heat them with the soldering iron and touch the solder to the wire after you heat it.

The soldering iron should be heating the wires and the solder itself applied to the wires not iron. Soldering two wires together requires a soldering iron and solder. Touch the red meter probe to the wire you are testing with the ignition in the accessory position.

I use Kester 44 or Kester 245. Solder the output wires to the desired input RCA. You melt the solder onto the wires to stick them together and as the solder cools it forms a permanent bond.

How to connect speaker wire to car or home speakers by soldering. Then use a pair of pliers to push the metal tap down into both wires flush with the body of the connector and snap the cover over the tap. Slide the existing wire into the open side of the connector then put the end of the wire you wish to connect to it into the other side.

So solder with the requiored heat only. Then remove wire insulation before joining the wires together and place the hot soldering iron over the wires to join them with an iron strip together to the speaker or amplifier terminal. The accessory power wire is at 0V with the ignition in the off position and switches to 12V in the accessory position.