How To Solder 2 Copper Wires Together

Place the tip of the solder at the point where the solder iron tip and part you are soldering meet.

How to solder 2 copper wires together. Wrap them tight to form a good mechanical connection. Plug the soldering guniron into an electrical outlet and allow it to heat up for about three to five minutes. Tin the soldering gun ie melt a little solder on it.

When soldering wires with a big diameter it is not easy to bend or twist them. Hold the solder in place for a few seconds until solder starts to flow. How to Solder Two Small Wires - YouTube.

Touch the tip of the soldering iron to the copper wires. This technique is good for both stranded wires and solid wires. Its now time to demonstrate how to solder wires together.

So place the tip of the soldering gun underneath the wire and feed just a little bit of solder in between the tip and the wire. Place soldering iron under the wire. Clean pads on a circuit board with a pencil eraser.

For low voltage applications fan out the copper strands and then twist them together. Yes copper and stainless steel can easily be soldered or brazed together using a filler material that usually contains tin and silver. We need to heat up the copper wire using our soldering gun.

Cut the two wires to be soldered together to the appropriate length as needed for your project. Lap them together and wrap a small gauge wire 28-30AWG around the two several times. Lay them together overlapping at the soldered part then blob them together.