How To Replace A Soldering Iron Tip

You can purchase a new tip online or at your local hardware store.

How to replace a soldering iron tip. Depends on your soldering iron. Gently touch the soldering iron tip to the specified position of the sensor about 5 seconds Read the test temperature T result from iREWORK software or LCD Screen PS Usually stays in the range of about 3C 5C Due to once the test sensor oxidizes it will become mor difficult to accurately measure the temperature Please replace the sensor after approximately 50 measurements. Start by turning off the soldering iron remove the iron and using a pair of pliers or some other kind of gripping tool to hold onto the hot metal parts clamp it down and unscrew.

When you are finished soldering apply a thin layer of solder to the tip this will help prevent oxidation Never use the tip as a pry bar or screwdriver Use the lowest temperature possible this will prevent premature wear tot he tip and damage to the components Always use a tip. Once the locking nut has been unscrewed and you have extracted the sleeves tip you can now take the new replacement soldering iron tip and then fit it in your sleeve and then slide it back on you soldering heating element just like it was before. Avoid over-tightening the locking nut.

Take your replacement soldering iron tip and fit it into the sleeve and slide it back on the heating element as it was before. There are endless varieties of specialized tips designed for specific jobs even if they arent soldering relatedFor example this spade tip is used to scrape UV glue off of LCD glass. So you will need to replace the current.

If applied evenly this will keep the irons heat flow in check when it is next used in addition to preventing rust accumulation. Install the prepared tip in your soldering iron. Apply a small amount of fresh solder to the iron tip.

This should go without saying but if youve just been using or trying to use your soldering iron let it cool down before replacing the tip. Switch off iron and allow to cool Slide bit retaining spring forward until it is clear of the slot in the bit. Although you can check out our newest cordless soldering irons here and we do have a great upgrade program you can.

Place the desired tip into the retaining sleeve and slide it back onto the soldering. If some of the oxides are just sticking really well you could try to mildly abrade them on a brass sponge copper braid or similar but you cant be too hard or you will damage the iron plating good tips are typically copper core plated with iron then chromium everywhere but the working area. Slide the nut and retaining sleeve off the soldering iron heating element and remove the tip from the sleeve.