How To Remove Soldering Iron Tip

Probably best not to fill all the voids by over-applying - soldering iron temperatures drive out the silicon grease and the oxide filler sets like cement but a thin smear helps stop things sticking fast.

How to remove soldering iron tip. Once your iron is heated up for a job wipe it on a wet sponge to remove old solder and apply solder to the tip. Switch on the Soldering Station or the Iron and Make sure it is Hot Enough. Each time you clean the soldering iron and put it away apply a fresh solder to the tip.

Use stainless steel wool flux and thick clothe to clean the tip. Keep the tip clean Keeping a tip clean is also a solid strategy to reduce oxidation. After trying both the sponge and flux to clean the tip of your soldering iron sal ammoniac would be the next step if the others didnt work.

Wipe the iron on a damp sponge to remove the excess. This should lead to a clean shiny tip ready for use for more info see this video. How to Clean Soldering Iron Tip.

Melt some good quality of solder wire on the Tip. To use the Tip tinnercleaner heat the soldering iron. Repeat the Process 3-4 Times until the Soldering Tips start Shining.

If it doesnt you need to remove all solder and grind the tip again more thoroughly. This should lead to a clean shiny tip ready for use. For soldering iron tip made of copper.

Install the prepared tip in your soldering iron. Clean the tinned tip and you have a refurbished soldering tip. Wipe the iron on a damp sponge to remove the excess.