How To Properly Solder Wires

The solder should become liquid.

How to properly solder wires. How to Solder Wires. Bring the soldering iron tip close to the twisted wiring. You should cover all of the wires with solder.

Cut the wires to the. Repeat this process on the other wire. Fold over the wire connection.

Well I may not know the absolute best way but heres an awesome video by ChrisFix explaining absolutely all there is to know about soldering wires the proper way. Do not over tin the wire or solder may flow up under the wires insulation causing it become rigid or you will end up with globs of solder on the terminal that will have to be removed. You must tin the wire and the most.

Tools need will be a soldering iron heat machine rosin flux solder 3M silicone dielectric grease wire s. And then hold the soldering iron for 3-5 sec unless the Solder is melted. Make sure to heat it before because of that the Solder melts and joints with the connector.

Then remove your hand and hold the twisted section with a plastic stick. Take your solder and touch at the point where the iron and wire make contact. Once youve got it figured out and have done it a couple of times its very easy to do this in a matter of seconds whenever you need to.

Once cool inspect the union to ensure proper penetration of the solder. Wrap one or two inches of solder around the tip while the iron is cold. The trick to soldering is making sure that the joint is fully heated through and not a cold-solder joint.