How To Properly Solder Wires Together

When you solder items together youll typically be using the hot metal tip of the iron to melt a small amount of solder alloy around and between the components or surfaces being joined.

How to properly solder wires together. Be able to solder most small electronic components and small circuits together yourself. Touch the iron and solder to a few points on the splice to make sure it is uniformly spread throughout the wire strands. Make sure to hold the wire and connector together.

The challenge is holding the wires in place long enough for the solder to cure. Apply Solder Flux to the Wire Joint. You should cover all of the wires with solder.

Learn How to Solder Correctly. Secure both sides of the rejoined wire so they wont move when touched with the iron. Make sure your soldering iron is fully heated and touch the tip to the end of one of the wires.

Some say its better to joint the two wires using a Y-splice while some only swear by the good ol rat tail splice. Place soldering iron under the wire. And then hold the soldering iron for 3-5 sec unless the Solder is melted.

But even in the soldering community theres still room to argue. For large gauge wires 14awg for an antenna perhaps make a Western Union splice then solder it. The second joint will likely go quicker than the first one.

Touch the tip of the soldering iron to the copper wires. Let it take some time. As the solder melts it will flow into the fitting.