How To Make Soldering Wire In Hindi

Set the iron to the solders temperature range.

How to make soldering wire in hindi. Keep the iron in place and touch the solder to the wire until its fully coated. Once the connection evenly turns the correct silver color of solder remove the soldering iron and allow the joint to cool. You want a flattish roundish piece when done thats easy to hold in a bird beak pliers.

Make sure the soldering iron has warmed up and if required use the moist sponge to clean the tip. Run the solder over the entire splice so it can melt and travel into the gaps between the wires. If you use a cold iron it will form solder bridges more readily.

Place the soldering iron on the component of the pad and feed the solders end onto the board. Clean soldering iron tip to the copper solder pad and the component lead in order to heat both items at the same time. Stranded wire is better for lap joints than solid wire because its lower bending stiffness makes peeling loads smaller when the joint is pulled on from both ends.

There is an exception through hole components require you to solder while holding the solder Use the solder to tin each wire andor surface youre soldering. Preparing the Copper Wire Strip is the copper wire and cut a piece of 3 inch and 2 pieces of 15 inch Bending the piece of 3 inch and twist the ends together. Too much or too little flux will cause problems with the solder attaching to the parts.

And allow the solder to melt. Solder should only be used to tin the wire. Take the copper tip 1 a piece of 710 cm of 345 mm diameter copper rod and roll the insulator over it on about 4 cm.

Soldering Small Wire to Pad. Hold it on the wire for 3-4 seconds. Left Continue heating and apply a few millimetres of solder.