How To Make Soldering Iron Wire At Home

Make sure that the wires to be soldered are perfectly clean.

How to make soldering iron wire at home. When soldering there are a few. Take the copper tip 1 a piece of 710 cm of 345 mm diameter copper rod and roll the insulator over it on about 4 cm. Make a heater resistor by attaching one end of heater nichrome wire of 03 to 05 mm in diameter and winding it over the insulator.

At this point plug the usb cable into a computer or usb wall outlet and ensure you have a good working connection. Heat the exposed wires with the soldering iron and coat the ends with a thin layer of soldera process called tinningto ensure the wires form a proper connection. Once the flux starts bubbling you can begin adding solder.

Now using a second working soldering iron solder the black wire to the negative coil and the red wire to the positive plate below the switch. If you want them to remain firmly connected youll have to make use of a normal tape to cover them together. The heat will transfer from the iron and into the wires so the flux turns into a liquid.

Then connect two pieces of thin copper wires at the two ends of the wire insulations. We will use the remaining 20 for wielding. Heat the wire until the whole joint melts together.

Use liquid flux on the bare wire terminal. Attach one end of the heater nichrome wire about 0305 mm diameter near the sharp end 3 and start winding it over the insulation to make the heater resistor 4. The tip of the soldering iron will be made by the thick copper wire.

Cut a copper tip of about 7 to 10 cm long and 3 to 45 mm diameter of a copper rod. Do it as shown in the photo. Make sure that you twist them firmly.