How To Make A Soldering Iron Stand At Home

Touch the solder to the tip of the iron and make sure the solder flows evenly around the tip.

How to make a soldering iron stand at home. Wipe the tip of the soldering iron on a damp wet sponge to clean it. It Can Accommodate Hakkos 599B Tip Cleaner Too. ABOUT THE EXPERT Jeff Koskulics Jeff.

Wait a few seconds to let the tip heat up again before proceeding to step 4. Features weighted stable base. Touch the solder to the tip of the iron and make sure the solder flows evenly around the tip.

Accommodates the standard cleaning sponge. Using tweezers place the component in its correct position and hold it there. Wipe the tip of the soldering iron on a damp wet sponge to clean it.

Before you start using the tool clean the tip with a wet cleaning sponge and continue to clean it throughout the process. As you do this make sure to touch the graphite using a free wire connected to the ground. This method is for soldering chips.

As usual start by applying flux to the pads on the circuit board. Learn about soldering irons soldering guns circuit boards and more from Jeff Koskulics in these Howcast videos. Solder is melted by using heat from an iron connected to a temperature controller.

Optional tip cleaner to the sponge is the brass coils with the holder. Begin taking a piece of the solder and placing it on the corner of your box frame applying heat from the soldering iron to fasten the corner. - since it is now locked onto the broomhandle get your metal-blade hacksaw and cut the wire exactly where it enters the hole.