How Do You Solder Small Wires

Step 1 - Turn Off the Power.

How do you solder small wires. Tin coat with solder the soldering tip first. You could also twist them before soldering to increase mechanical strength. There are small lies big lies and then there is.

Begin by removing the insulation from the ends of both wires you are soldering together. Run the tip of the solder on top of the wire so it melts into the wires. Keep the iron in place and touch the solder to the wire until its fully coated.

Step 3 - Strip the Wires that are Being Connected. In the old days radio and television engineers utilised the 60-40 solder mix. After you put the wire in a hole heat the junctionof the wire and hole until the solder on the wire and hole melt should take no more than 2 seconds.

To do this heat up the soldering iron and touch the solder to the tip of the iron so that you cover the tip in a thin layer of solder. Make sure your soldering iron is fully heated and touch the tip to the end of one of the wires. Step 4 - Place the Two Stripped Ends Together.

For small wires and quick jobs you could simply solder one wire directly next to the other. Step 5 - Place the Connector Over the Ends of the Wires. Place the tip of the soldering iron against the solder pad.

Remove both the solder and the soldering iron tip from the connection as soon as enough solder melts onto the pad. The best thing is 14-gauge steel wire as it heats fast but retains heat fast enough to solder with. Tap the end of the 6337 solder on top of the wire splice so the solder melts down into the wires.