How Do You Make A Soldering Iron Tip

Wipe the iron on a damp sponge to remove the excess.

How do you make a soldering iron tip. If the iron doesnt have replaceable tips get rid of it. Wipe clean before using. A classic reason solder wont stick to something is because youre not getting it hot enough.

If all else fails Soldering Iron tips do not last forever. This sponge is used to clean solder off the tip of the soldering iron. Place the soldering iron tip onto the sensor and apply solder as if you were making a solder connection.

Then dip into the tin of tinner cleaner with a slight twisting action. Press the blob of solder into the metal to be soldered. If youve not had the tip long then a few pointers to keep in mind.

This should lead to a clean shiny tip ready for use. This should lead to a clean shiny tip ready for use for more info see this video. When doing this slowly coil the wire until it achieves your desired diameter or area and having a measuring gadget would be ideal to confirm the requirements are as required.

Touch some solder on it and it should melt almost instantly. Using water soak the sponge that comes with the iron and squeeze it out a little. If the locking nut is stuck you can use a small set of pliers to loosen the locking nut.

Melt a small dot of solder over the tip in a thin coat. To protect your soldering iron tips you should tin your tip before and after soldering to create a protective layer between the air and the. The third tool is needed once you combine the solder iron and the soldering wire Im talking about the brass wire since the burning flux leaves dark marks on the soldering spot and on the tip of the soldering iron.